Continuously hot rolled non-coated, non-alloy mild steel sheet/plate and strip for cold forming and bending Tolerances on dimensions and shape. November 1981

U.D.C.: 669.14.018.26-122.4-418 November 1981 Continuously hot rolled non-coated, non-alloy mild steel EURONORM sheet/plate and strip for cold forming and bending 112-81 Tolerances on dimensions and shape CONTENTS 1 FIELD OF APPLICATION 4.1 Thickness 2 DEFINITIONS 4.2 Width 3 TOLERANCES FOR SHEET/PLATE AND CUT 4.3 Flatness LENGTHS 4.4 Edge camber 3.1 Thickness 5 MEASUREMENT 3.2 Length 3.3 Width 5.1 Thickness 3.4 Flatness 5.2 Length 3.5 Out-of-squareness 5.3 Width 3.6 Edge camber 5.4 Flatness 3.7 Superimposement of dimensions 5.5 Out-of-squareness 4 TOLERANCES FOR WIDE STRIP AND STRIP < 600 MM WIDE SLIT FROM WIDEP 5.6 Edge camber 1 FIELD OF APPLICATION — flat products in high yield strength steels for cold This EURONORM applies to continuously hot rolled non-coated non-alloy, mild steel sheet/plate, strip and lengths forming, cut from it, in thicknesses less than 8 mm, intended for cold — non-alloy steel sheet/plate and strip for boilers and forming or bending. The quality requirements for pro­ pressure vessels, ducts covered by this EURONORM are specified in — magnetic cold and hot rolled sheet/plate and strip, EURONORM. 111. — sheet/plate intended for the manufacture of tin plate, —ed for heat treatment, It does not apply to products for which there exists a — strip for re-rolling specific EURONORM and, in particular, to the following — sheet/plate and strip for welded steel gas cylinders.