Text in Support of Comment #91

85.8.4.2 Receiver interference tolerance test at TP3 The receiver interference tolerance tests shall be implemented using the receiver interference tolerance parameters summarized in Table 85–7. The tests are to be applied to all 10GBASE-CR4 or 10GBASE-CR10 lanes. The receiver interference tolerance test at TP3 is similar in basic principle to the test specified in Annex 69A. Parameter Test 1 Test 2 Units Value Value -12 -12 Target BER 10 10 Minimum fitted insertion loss coefficients a =2.15 a =6.04 dB /root-GHz1 1 a =0.78 a =0.94 dB /GHz2 22 a =0.03 a =0.08 dB /GHz4 4a Applied SJ (min. peak-to-peak) '0.115 '0.115 UI bApplied RJ (min. peak-to-peak) '0.130 '0.130 UI Applied DCD (min. peak-to-peak) '0.035 '0.035 UI Calibrated far-end crosstalk (min. RMS) '6.0 '2.2 mV Calibrated ICN (min. RMS) - MDNEXT '3.7 '3.7 mV a Applied SJ frequency >15 MHz , specified at TP0 b Applied random jitter at TP0 is specified at 10–12 Notes to reviewer: Test 1 Calibrated far-end Crosstalk RMS =9.6mV (from Equation 85-81) * 400mV/600mV (to because all Tx's should match amplitude) * .89 (from ratio of sigma nx to total, case G in healey_02_0709 RSSed with 2mV Tx noise from 85.8.3.2 Test 2 Calibrated far-end Crosstalk RMS =4.7mV (from Equation 85-81) * 400mV/600mV (to because all Tx's should match amplitude) * .625 (from ratio of sigma nx to total, case H in healey_02_0709 RSSed with 1mV Tx noise from 85.8.3.2 85.8 ...