LS-PREPOST ROLLER HEMMING APPLICATION TUTORIAL MANUAL

LS-PREPOST METAL FORMING APPLICATION TUTORIAL MANUAL

LIVERMORE SOFTWARE TECHNOLOGY CORPORATION




LS-PrePost®

Metal Forming Simulation
− − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − − −
Tutorial Manual – Trimming and Springback




Version 1.0
April 2009


Copyright © 2009
LIVERMORE SOFTWARE TECHNOLOGY CORPORATION
All Rights Reserved
1
LS-PREPOST METAL FORMING APPLICATION TUTORIAL MANUAL

DISCLAIMER
THE INFORMATION IN THIS TUTORIAL ARE FOR ILLUSTRATION PURPOSE ONLY AND ARE NOT
INTENDED TO BE EXHAUSTIVE OR ALL-INCLUSIVE, THE LS-DYNA KEYWORD FILES PRODUCED BY
LS-PREPOST MAY NOT BE EXHAUSTIVE OR APPLICABLE FOR ALL ENGINEERING PROBLEMS, LSTC
ASSUMES NO LIABILITY OR RESPONSIBILITY FOR ANY INACCURACY OR DIRECT OR INDIRECT
DAMAGES RESULTED FROM THE USE OF THIS DOCUMENTATION AND SOFTWARE.

















2
LS-PREPOST METAL FORMING APPLICATION TUTORIAL MANUAL

Table of Contents

Tutorial #T1 – Trimming of a decklid inner drawn panel .......................................................................... 4
Tutorial #S1 – Springback of a decklid inner trimmed panel ... 16


3
LS-PREPOST METAL FORMING APPLICATION TUTORIAL MANUAL

Tutorial #T1 – Trimming of a ...