Deep Publish Tutorial

Deep Publish 5.0 Tutorial The Basics Welcome to the world of 3D with Right Hemisphere! The aim of this tutorial is to learn how to use Deep Publish to: • Add 3D content to a Word document. • Changing from Image to Interactive mode. • Interacting with the 3D model. • Converting the document to 3D PDF. Assumptions Certain assumptions have been made regarding this tutorial: • You should be familiar with 3D concepts. • You should be familiar in the use of Microsoft Windows. • You should be familiar in the use of Word. • Note that the model displayed on your screen during this tutorial may be different depending on the graphics card you have installed in your computer, the screen geometry, and the colors and placement of objects that you choose. Features Covered • Inserting a 3D model into a document. • Converting a document containing 3D content to a 3D PDF. • Converting a D content to a 3D PDF and sending it to a recipient via email. Requirements The following software and files are required for this tutorial are: • Deep Publish version 5.0.xxx • Adobe Acrobat Professional version 7.0.x or higher or Acrobat 3D 7.0.7 or higher. The files required for this tutorial are: • a 3D file accessible to your computer. Completion Time This basic introduction should take approximately 15-20 minutes to complete. Copyright © Right Hemisphere 2007. All Rights Reserved Page 1 Inserting a 3D Model into a Document When Deep Publish is installed, ...