1585031860 - Pro ENGINEER WILDFIRE 2.0 Tutorial

INSIDE: ®MultiMedia CD Pro | ENGINEER ™ W I L D F I R E 2.0 An audio/visual presentation of the tutorial projects Tutorial and MultiMedia CD Roger Toogood, Ph.D., P. Eng. SDC PUBLICATIONS Schroff Development Corporation www.schroff.com www.schroff-europe.com Creating a Simple Object (Part I) 2 - 1Lesson 2Creating a Simple Object (Part I)Introduction to SketcherSynopsisCreating a part; introduction to Sketcher; Sketcher constraints; creating datum curves,protrusions, cuts; using the dashboard; saving a part; part templates.Overview of this LessonThe main objective of this lesson is to introduce you to the general procedures for creatingsketched features. We will go at quite a slow pace and the part will be quite simple (see Figure 1on the next page), but the central ideas need to be elaborated and emphasized so that they are veryclearly understood. Some of the material presented here is a repeat of the previous lesson - takethis as an indication that it is important! Here’s what we are going to cover:1. Creating a Simple Part2. Feature Types and Menus3. Introduction to Sketcher< Sketcher menus< Intent Manager and Sketcher constraints4. Creating a Datum Curve5. Creating an Extruded Protrusion< Using the Dashboard6. Creating an Extruded Cut7. Saving the part8. Using Part TemplatesIt will be a good idea to browse ahead through each section to get a feel for the direction we aregoing, before you do ...