Ezra, Roman – I need installation drawings to go with each of these steps

Polygal Inc. Hurricane Panel Installation Instructions-POLYGAL 16mmSG SHEET. Tested in accordance with FBC-204 – TAS 201, 202, 203; 2003 ICC, IRC, IBC; ASTM E 1886-02, E 1996-02; ASTM E 330-02 READ ALL INSTRUCTIONS BEFOR STARTING 1. Not for openings larger than 66” x 90”. 2. Maximum sheet size 72” x 96”. 3. Sheets must be attached on all four sides in accordance with these instructions. 4. Sheets must overlap opening a minimum of 3” on all four sides. Step 1 – 16mm SG sheets – Cut sheet width and length to overlap opening on all sides 3”. (Sheet “length” is the direction of flutes). Exterior UV treated surface has printed masking. Mark the exterior surface with marker pen before removing the masking. Install sheets so that the exterior UV treated surface is the side exposed to the sun. Step 2 – 2” U channel Cutting & Placement Sides – Cut 2” U channel exact length of sheet for left and right sides of sheet. Place on left and right side of sheet flush with sheet. The angled surface of the U channel should be on the exterior surface of the sheet. Step 3 – 2” U channel Cutting & Placement Top and Bottom - Measure inside distance, along top and bottom of sheet between left and right U channels. Make sure left and right U channels are flush with sheet before measuring. Cut the U channel to length and place on both top and bottom flush with sheet. The angled surface of the U channel should be on the exterior ...